>X-UIDL: 802715055.000
>From: Peter Dufault <dufault@hda.com>
>Subject: Re: NCR53c400 Magoptic Problem
>To: sjs1@primenet.com (Scott Story)
>Date: Fri, 9 Jun 1995 12:18:26 -0400 (EDT)
>Content-Length: 700
>
>Scott Story writes:
>(...)
>> >> sd0 (nca1) Direct Access
>> >> sd0 (nca1) Illegal Request ASC:24,0 invalid field in CDB
>> >> sdo could not mode sense (4), Using Fictitious Geometry, 281 (576999, 512
>> >> byte sectors)
>> >
>> >Does this happen even if you have the formatted media installed?
>> YES with 512 Media
>> There is 512 or 1024 byte sector media for the SMO501.
>
>The "ZIP" drives do this also, so this is not a problem - you can
>go on to use the ZIP drives.
>
>I'm not sure about the panic - it looks like an NCR driver problem.
(Thanks Peter)
This is the message from the setup any comments out there?
>> nca1/0/0/sd0/timed out
>> Fatal Trap 12: page fault in kernel mode
>> Fault Address=0x8
>> Fault Code=supervisor read, page np
>> install pointer=0x8:0xf0172c1b
>> code sequence= base 0x0, limit 0xfffff, type ox1b=DPL 0,pres 1, def 32,
gran 1
>> Processor eflags=interupt enabled, resume,10 PL=0
>> Current Process= 1 (sysinstall)
>> int. mask= bio
>> panic=page fault
>--
>
I want to die quietly in my sleep like my grandfather,
not SCREAMING! like his passengers <:)
http://www.primenet.com/~sjs1/index
sjs1@primenet.com