On Mon, 2003-01-06 at 20:11, Nate Williams wrote:
> Single receiver, but two cords coming out of it.
>
> > dmesg shows that both the mouse and kb were detected, mouse as ums0 and
> > kb as ukb0. XFree is set to use /dev/sysmouse, but dies with no core
> > pointer if I dont use the corded mouse.
>
> I hard-code the mouse and don't use sysmouse.
>
> > ukbd0: Logitech USB Receiver, rev 1.10/13.10, addr 2, iclass 3/1
> > ums0: Logitech USB Receiver, rev 1.10/13.10, addr 2, iclass 3/1
>
> Mine shows us as a ps/2 mouse. Is this a USB setup? Mine's a normal
> non-USB setup.
Single wire coming out that splits into a PS/2 connector and a USB
connector. If I plug just the USB connector in, dmesg shows both devices
however the kb doesnt work. Plugging in just the ps/2 plug I get kb
support but dmesg doesnt show the mouse. So I plug both in and have both
devices listed.
I also tried configuring xfree to use /dev/ums0 directly but it still
dies with no core pointer.
>
> Nate
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-current" in the body of the message