-----BEGIN PGP SIGNED MESSAGE-----
based on the chip id, your device should map to the generic Winbond
6692 with iwic just fine.
In any case, if you want to make a driver for an ISDN chip in BSD, you
should probably take one of the existing i4b layer1 drivers as a base.
You must implement the i4b internal l1mux interface towards the stack,
which is quite different from anything "regular" drivers do.
The bus probe/attach/intr functions are quite basic PCI stuff for them
too, though (usually split into <driver>_<bustype>.c).
On Sep 26, 2004, at 15:47, n0g0013 wrote:
> P.S: here is the output from pciconf -lv
> none2@pci0:11:0: class=0x028000 card=0x340916ec \
> chip=0x66921050 rev=0x01 hdr=0x00
> vendor = 'Winbond Electronics Corp.'
> device = 'W6692/92A/92CF PCI BusISDN S/T-Controller'
> class = network
> P.P.S: if this is a TA then i don't expect the iwic driver \
> will work. + the subdevice id's don't match any in the \
Juha-Matti Liukkonen - Systems Architect, Cubical Solutions Ltd
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (Darwin)
-----END PGP SIGNATURE-----